Installation - Sartorius YSB01 Guia De Instalacion

1
6
4 3
2

Installation

§ Disconnect the YSB01 relay box from
power before opening the housing.
§ To open the relay box, remove the four
screws from the cover plate.
§ Installing the cable gland and cable:
– Prepare the cable opening by breaking
out the pre-punched M20 chip.
– Guide the enclosed cable gland
(M20 x 1.5) through the opening and
secure it inside the housing with the
counternut (1).
– Route the cable (2) through the cable
gland. Tighten the screw-down nut
(3) until the sealing clamp (4) forms a
slight ridge between screw-down nut
and cable.
§ Mount the cable on the relay card in
accordance with the relevant wiring
diagram (see below).