Multifunction Button; Basic Operation - Xtech XTH-700 Guía De Usuario

Earphone multifunction buttons with LED status indicators:

Multifunction button

Mode
Pairing
Press and hold to enable the pairing mode (if the earphones
fail to automatically go into pairing mode).
Hands-free mode
Briefly press to answer and end an incoming call
Press three times to redial the last number called (on
supported devices)
Press and hold for about 1 second to reject or ignore an
incoming call
Press and hold for about 2 seconds to enable the voice
command feature on the device
Playback mode
Briefly press the right or left button to play and pause audio
LED indicators on earbuds
Status
Charging
The LED turns solid red
Charging complete
The LED turns off
Power on
Initially, the LEDs light up in blue on both earphones, then the
left earphone LED starts flashing red and blue. The right
earphone LED lights up in blue once every 5 seconds
Function
Function
Status
Power off
The LEDs glow red, before turning off completely
Pairing mode active
The LED on the right earphone tuns solid blue, and the
LED on the left one flashes red and blue alternatively
Left or right channel Blue LED lights up once every 5 seconds
enabled
Bluetooth connection When the device has paired, only the blue LED will blink once
®
every 5 seconds on both earphones
Standby
The LED on the right earphone stays solid blue and on the left
one, the LED stays solid red
Low battery
Red LED blinks once every second
Incoming call/ Dialing
Blue LED lights up once every 5 seconds
Phone is on active call
Blue LED lights up once every 5 seconds
IV. Basic operation
4.1. Charging the case and earphones
Note:
- The case and earphones have internal, non-removable, rechargeable batteries.
Do not attempt to remove the battery as you may damage the device.
Function