Westinghouse 75015 Manual De Instrucciones página 20

FIGURE 1.
F
G
MOUNTING AND WIRING INSTRUCTIONS
GB
NOTE: Line art shown may not exactly match the fixture enclosed. However, the installation
instructions do apply to this fixture.
The light source of this luminaire is not replaceable; when the light source reaches its end
of life the whole luminaire shall be replaced.
1. Turn off power at circuit box to avoid possible electric shock.
2. Place mounting bar (B) flush against wall at desired mounting location. Using outside
mounting bar holes as a guide, mark where pilot holes are to be drilled.
NOTE: Mounting bar (B) must be level for fixture to hang straight.
3. Inset two plastic anchors (D) into the pilot holes (for drywall).
4. Align outside mounting bar holes with plastic anchors (D) (If applicable). Secure mounting bar
(B) into place using wood screws (E).
5. Make an electrical connection by loosening the terminal screws on the terminal block (F) and
inserting the live, neutral and ground terminals.
6. Tighten terminal screws. Make sure there are no stray wires.
7. Position back plate (G) over mounting bar (B) by aligning back plate openings on edges on
back plate with the screw holes on mounting bar (B).
8. Replace screws (A) onto the edge of back plate (G).
9. Adjust the pitch of the fixture head to the desired position. (refer to the Pitch Adjustment
drawing in fig.1)
10. Turn power back on at circuit box.
20
D
B
E
A
GS-26-RS24-WH21