Operation; Important - Domair MASTERCOOL9 Instrucciones De Uso

OPERATION

1. 'Mosquito' Mode
2. 'anion' mode
3. 'swing' mode
4. 'Cooling' mode
5. 'Ventilation' mode
6. on/oFF
Connect the appliance to the power
supply. the light
that the appliance is connected to the
power supply.
Press the button
or on/oFF on the remote control to start
or stop the unit. after switching on, the
indicator light turns blue. The device
can then be controlled as follows:
touch key : selection of fan speeds.
with each push, a new speed is selec-
ted according to the following cycle: 1
= low, 2 = average, 3 = high. the light
corresponding to the selected mode on
the control panel comes on.
touch key : activate and deactivate
the air sweep (vertical grid). the corres-
ponding indicator lights on the control
panel when sweeping is enabled.
touch key : activation and deacti-
vation of the water pump and humidifi-
cation of the air ('Cooling' mode)
Rev 0-21 11 19
comes on indicating
on the control panel
Fabriqué en Chine
IMPORTANT: An air refresher does
not lower the ambient air tempera-
ture of a room. It humidifies the air,
making it feel fresher.
note: when the cooling mode is activa-
ted, the pump inside the tank pumps the
water to saturate the cooling filter. The
air passing through the filter is therefore
saturated with water giving a feeling of
freshness. thus, the feeling of fresh-
ness in 'cooling' mode depends on the
relative humidity of the air. Therefore,
when the HIGH fan speed is selected,
when switching to 'cooling' mode,
the speed will automatically drop to
LOW for 30 seconds, then the selected
speed will be operational again.
touch key : activate and deactivate
the anion mode. the ioniser is used to
purify the air: the negative ions genera-
ted by the device (anions) act directly on
the polluting particles suspended in the
air which are positively charged (posi-
tive ion = cation). the anions capture
the cations by attaching to them and fal-
Page 26