Important; Operation - Domair COOLCUB Instrucciones De Uso

Enfriador de aire
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

In order to avoid reducing the performance of the device, it is recommended
not to use it in an environment that is too polluted or too humid.
Do not expose the device to direct sunlight for an extended period of time.
Use only the adapter supplied.
For best results, place the device on a table or desk during use.

IMPORTANT:

-
the water for refilling must always be fresh and clean. Never use anything
other than water.
-
To avoid the risk of unpleasant odours: completely empty the tank at
least once a week and clean it; operate the device in high fan mode for
at least 5 minutes before switching it off.
-
Never leave water in a device that is not being used.
-
In case of prolonged non-use, drain the appliance completely (see
paragraph MAINTENANCE). If this instruction is not respected, the
warranty does not apply.

Operation

9. Connect the device to the power supply as indicated in the previous
paragraph.
10. Press the button
11. Press the button
a new speed is selected according to the following cycle: low, average, high.
The corresponding lights turn on on the control panel: 1 light = low speed; 2
lights = average speed; 3 lights = high speed.
12. Press the button
possible to choose a fixed lighting colour, or lighting with that changes colour
according to a cycle. The available colours are: green, red, blue, turquoise,
purple, white, yellow.
IMPORTANT: An air cooler does not lower the ambient air temperature of a
room. It humidifies the air, making it feel fresher.
Rev 1_ 16 01 20 Fabriqué en Chine Page 23
to start or stop the device (Fig.4).
to select the desired fan speed (Fig.5). With each push,
to choose the desired atmospheric lighting (Fig.6). It is

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Draf-122min

Tabla de contenido