Important - NuWave BruHub Manual Del Usuario

ASSEMBLY GUIDE
Fill water directly in the Water Tank when attached, or remove first.
To fill directly in the Water Tank:
1. Lift the Water Tank Lid
up and pour in water to
appropriate fill line.
2. Close the Water Tank Lid.
• Coffee maker will not
operate when tank is
removed or when there
is no water.
To fill Water Tank when removed:
1. Lift Water Tank Lid and place to
the side.
2. Lift Water Tank up to remove from
the side.
3. Fill to appropriate fill line.
4. Slide Water Tank straight down,
ensuring the hooks fit snug with
Water Tank.
5. Place Lid back on top of Water Tank.
12 12
assembly guide
MAX Fill Line
Full Carafe
Half Carafe
12oz Cup
8oz Cup
MAX Fill Line
Full Carafe
Half Carafe
12oz Cup
8oz Cup
IMPORTANT: When raising Mug
Tray to a higher level, insert into
holes. Press down to ensure Mug
Tray is secure.
With your NuWave BruHub 3-in-1 Coffee Maker, you can choose from
three different inserts to customize your coffee-drinking experience
and preference.
Custom Brew Insert
1. Place Filter Basket inside Custom
Brew Insert.
2. Line up dots with each other and
place Custom Brew Insert directly
down into Insert Chamber.
3. Fill with appropriate amount
of coffee grounds.
4. Close lid.
• Use 8, 12, half carafe, and
carafe for Custom brew option.
• Always use NuWave's
customized carafe when using
the Custom Brew Insert.
Note:
The Carafe Lid must always be used.
DO NOT brew without Lid.
For single serve K-Cup
®
1. Insert the K-Cup into the Single Serve Insert.
®
2. Press firmly until you hear a click.
3. Make sure lid is fully closed.
4. Use Mug Tray on Drip Tray Base and Screen for smaller cups and mugs.
5. Use 8 and 12 sizes for Single Serve Insert.
Single Serve Insert with BruCup
1. Line up dots and place Single Serve
Insert into the Insert Chamber.
2. Unlock the cap on the BruCup by
turning to the unlock position and
lifting up.
• The cap on BruCup is detachable.
3. Add ground coffee into the BruCup.
Do not overfill past Max line.
4. Place cap back onto BruCup and
turn to lock position.
5. Place BruCup into the Single Serve
Insert by lining up the tabs in the
front of the BruCup to the front of
the Single Serve Insert.
13 13
nuwavenow.com nuwavenow.com