ASSEMBLY GUIDE
6.
Close down lid.
• Make sure lid is fully closed.
• Use Mug Tray on Drip Tray Base and Screen for smaller cups
and mugs.
• Use 8 and 12 sizes for Single Serve Insert.
CAUTION: May be hot. Do not open immediately after brewing.
Hot Water Insert
Line up dots with each other and
place Hot Water Insert directly
down into Insert Chamber.
Close lid.
• Use Mug Tray on Tray Base for
smaller cups and mugs.
• Use 8, 12, half carafe, and carafe
for Hot Water Insert.
Carafe assembly
1.
Place Carafe Lid on top of
Carafe Base.
Note:
The Carafe Lid must always be used.
DO NOT brew without Lid.
14
14
assembly guide
2.
Line up dots by turning
clockwise to lock into place.
INSTRUCTIONS
Power button:
1.
Press Power once to turn your BruHub on. There will be a blue
light next to Power to indicate the unit is on.
• When you press the Power, there will be a red light next to
preheating. Once it has preheated, the red light will turn off,
indicating the water is ready to brew. Once it has preheated,
press brew. Press brew. Once preheated, the BruHub will
begin to brew.
• Your BruHub will maintain the correct brewing temperature.
There is no need to preheat in between cups.
• Unit will beep when your brew is complete.
2.
Press Power again to turn the unit off.
• If nothing is pressed within 1 hour the BruHub will
automatically shut off.
Temperature selection function:
You can now have the perfect temperature for your favorite beverage.
1.
When you first turn your BruHub on, the default is set for 185°F.
Depending on which brew function and size you chose, the
recommended default temperature will be set.
• 185°F is recommended when using single-serve pods.
• 205°F is recommended when using grounds and the Custom
Brew Insert.
2.
If you wish to adjust the temperature, press temp to change
the selection to 205°F, 175°F, and back to 185°F. Refer to the
Temperature Selection chart for more information.
Note:
After you customize any of the BruHub's settings, the unit will retain
that setting the next time you brew. If you remove the BruHub
from the power source and later plug it back in the BruHub will
15
15
nuwavenow.com
nuwavenow.com