Purpose Of This Manual; Description Of Operation; Identification; Setup And Operation - Southwire HB1A-9 Instrucciones De Operación

PURPOSE OF THIS MANUAL

This manual is intended to familiarize all personnel with the safe
installation and operation of the following Southwire Tools and
Equipment: HB1A-9 Universal Cable Tray Roller.
Keep this manual available to all personnel. Replacement manuals
are available upon request at no charge at
www.southwiretools.com.

DESCRIPTION OF OPERATION

The HB1A-9 Universal Cable Tray Roller guides are designed to
quickly and easily clamp-on to most cable trays and hinge open
and close to allow cable to pass through while guiding wire along
the cable tray and reducing pulling tensions during a cable pull.
Multiple configurations based on additional mounting platforms. Multiple configurations based on additional mounting platforms.
5

IDENTIFICATION

HB1A-9
1. Roller Locking Pin
2. Heavy Duty Tray Rollers
3. Mounting Bracket
4. Mounting Bracket Locking Pin
5. Tray Support Bracket
6. Side Guide Rollers
1
5

SETUP AND OPERATION

HB1A-9 VERSIONS
HB1A-9STC
1. The HB1A-9 Side-Tray Clamp version can be clamped to the side
wall of the cable tray. This is useful for guiding cable through bends
or risers - Attach Foot to horizontal bar of cable tray to secure in
place.
2. Loosen "T" handle clamp on the base of the cable tray roller and
install onto side rail of cable tray.
3. Ensure Tray Support Bracket (5) is installed over horizontal bar of
cable tray and pin into place.
4. Tighten "T" handle clamp ensuring there is no obstruction on the
inside of the cable tray.
6
2
6
1
3
4