Filling The Water Chamber; Detaching Your H4I - ResMed H4i Guia Del Usuario

Filling the water chamber

1
1
Open the cover.
2
Remove the water chamber.
3
Fill with fresh, clean water up to or below the maximum water level mark.
Note: The water chamber must be removed from the H4i before it is filled or water
may enter the flow generator. The spill guard must also be in place.
4
Return the water chamber to the docking station.
Note: Ensure that no water is collected between the heater plate and the water
chamber.
5
Close the cover ensuring that it clicks into place.
CAUTION
!
•
Do not overfill the water chamber as water may enter the flow generator and
air tubing.
•
Do not use any additives (eg, scented oils and perfumes). They may reduce
the humidification output of the H4i and/or cause deterioration of the water
chamber materials.

Detaching your H4i

1
1
Unplug the power cord from the power outlet.
WARNING
!
Take care when handling your H4i. The water and the water chamber base may
both be hot. Allow 10 minutes for the heater plate and any excess water to cool.
2 Remove the water chamber from the docking station.
3 Press the large silver button located midway underneath the docking station.
2
3
2
3
4
Setting up your H4i for use 3