Publicidad
Idiomas disponibles
Idiomas disponibles
Dear Client,
Congratulations for choosing one of our quality products. Please follow these instructions carefully and keep them with you.
Installation and connection of the equipment
Select a suitable mounting location which satisfies the following conditions:
• dry,
• as free from dust as possible and
• good air circulation.
Select a mounting location which is not obscured by mirrors, metal shelves, etc. There should be no equipment in the
vicinity of the sender and receiver which generates a strong magnetic field, e.g. mobile telephones, radios etc. These items
can have a considerable effect on the transmission and can shorten the range correspondingly.
Installation of the camera
1. Camera objective
2. BNC Easy-plug
3. Holder
4. IR LED
5. CDS LED
Connection of the camera
1. Select a mounting position on the rear bumper (normally in the centre).
2. Screw the camera holder to the bumper.
3. Connect the power cable to the vehicle reversing light, so that the automatic power supply is turned on when driving in
reverse.
4. Screw in the dipole or additional antenna for a good signal transmission.
Safety notice
Red cable = DC plus. The plus cable is additionally protected by a 3A / 250V DC fuse.
Black cable = DC negative. The plus cable is additionally protected by a 3A / 250V fuse.
Installation of the camera antenna
1.1. Screw the dipole antenna onto the antenna connection.
2. Fix the camera to the rear bumper or immediately behind the rear window.
6. Dipole antenna
7. Additional camera antenna
8. Power supply to the vehicle back light
d be carried out by an authorised specialist or workshop.
-1-
2.
If reception with the dipole antenna is insufficient, use the additional antenna instead.
Mounting on the boot lid:
1 Antenna
2 Holder
3 Bolt
4 Bolt
Installation of the receiver
1. Dipole antenna
6. Picture reversal
2. LED channel display
7. ON/OFF
3. OSD control button (+)
8. Channel select /automatic
4. OSD control button (-)
9. Monitor base
5. Function key (OSD for brightness,
10. Audio-Video output
contrast control etc.)
Notice:
Use the Function key to select the OSD features of Brightness / Contrast Control / Sharpness / Color / Hue / TV
Standard (Video) / VCOMA / VCOMD; adjust them by „Volume Control" Button. TV Standard (Video) is preset PAL.
VOL+
a. Gain the vocal volume
b. Gain the volume of each OSD features.
1. Open the car boot.
2. Place the holder on the folded edge of the boot lid.
3. Fix the holder by screwing both bolts tight.
4. Screw the antenna onto the holder.
11. Audio-Video input
12. DC supply voltage input
13. Additional antenna for receiver
14. Windscreen holder for LCD
receiver
VOL-
a. Reduce the vocal volume
b. Reduce the volume of each OSD features
-2-
Publicidad
