Westfalia 107905 Manual Del Usuario página 14

Function key
The system offers a variety of OSD features that allow useres to adjust manually for bst image performance.
Under each OSD, users can adjust the volume by pressing „VOL+" and „VOL-„ bottoms.
a. Press once for BRIGHTNESS adjustment.
b. Press twice for CONTRAST adjustment.
c. Press three times for SHARPNESS adjustment.
d. Press four times for COLOR adjustment.
e. Press five times for HUE adjustment.
f. Press six times for VEDEO (PAL/NTSC) adjustment.
g. Press seven times for BACKGROUND BRIGHTNESS adjustment.
h. Press eight times for LCD H. AMPLITUDE (scanning line) adjustment.
i. Press nine times for returning back to display mode.
Screen mirror view function
The system offers a variety of On-Screen display mode, this function is especially useful for mounting the camera at a
particular site (e.g. up-side-down from the ceiling).
Use of the monitor base
The monitor foot at the rear of the LCD receiver can be pulled out in order to stand the receiver on any stable surface, in
addition to use as a vehicle reverse driving system.
Connection of the receiver
1. Remove the magnetic stickers from the LCD receiver.
2. Apply the stickers to the rear side of the receiver.
3. IMPORTANT! Be careful when mounting the LCD receiver and holder on the dashboard. Select a safe and
comfortable position and fix the suction holder to the windscreen.
4. Press the fixing knob down to clamp the holder.
5. DC supply voltage input
Connect the switchable 12V / 24V car adaptor to the DC supply voltage input socket of the LCD receiver.
6. Cigar lighter socket
Connect the car adaptor to the cigar lighter socket. Operation is only possible when the ignition is turned on.
For a better performance, remove the dipole antenna from the LCD receiver and screw the additional antenna on it its place
-3-
Installation of the monitor antenna
If reception with the dipole antenna is insufficient, use the additional antenna.
1. Screw off the dipole antenna from the monitor.
2. Fix the monitor to the dashboard.
1.a. Antenna connector
1. Screw the additional antenna onto the monitor connector.
2. Fix the additional antenna to the roof.
3. Route the cable along the edge of the windscreen.
System Installation
Additional note: When mounting the camera, check the reception of the receiver before the final installation. One
person should hold the camera whilst another checks the reception. If faults or problems occur, refer to the details in the
troubleshooting section of this manual.
Follow these steps to install the system:
Receiver:
1. Connect the 12V / 24V car adaptor cable to the input socket in the lower cover of the LCD monitor.
2. Connect the 12V / 24V car adaptor to the cigar lighter socket. Operation is only possible when the ignition is turned on.
3. The LCD receiver's A/V input can be connected to a VCD/DVD player.
Camera:
1. Connect the 12V / 24V adaptor to the cable of your vehicle's reversing light. Now select reverse gear and the camera
will be activated automatically.
System settings:
1. The wireless colour TFT vehicle reverse driving system can be mounted in different types of vehicle, so that it
operates when reverse gear is selected.
2. Up to 3 cameras can be connected via 3 channels to the LCD receiver. The pictures received are shown in rotation at
5 second intervals.
A. Single-channel display
When one camera is connected:
1. Set channel 1 as camera 1, channel 2 as camera 2 or channel 3 as camera 3, or leave the factory adjustment as
marked on the channel sticker.
2. Select the desired channel by lightly pressing the channel-select button on the side of the LCD receiver.
3. The selected channel will be displayed on the LCD receiver.
b. Magnet
-4-