Campbell Hausfeld Cl157500AV Instrucciones De Operación página 3

and can cause serious personal injury if
used with air tools.
11. ALWAYS use attachments designed
for use with air powered tools.
Do NOT use damaged or worn
attachments.
12. Keep ALL nuts, bolts and screws
tight and ensure equipment is in safe
working condition.
13. ALWAYS secure workpiece in a vise
or clamp.
14. NEVER point an air tool at oneself
or any other person. Serious injury
COULD occur.
Pre-Operation
set-up InstRuctIons
Air tools require a supply of clean, dry air
at 90 PSI (6.2 bar). An air supply system
with filter, regulator, and lubricator (FRL)
as shown in Figure 1 should be used.
Campbell Hausfeld FRL model PA2104
(3/8 inch) or PA2114 (1/2 inch) is
recommended.
Figure 1
Water in the air supply can damage the
tool. Drain condensate from compressor
tank and filter daily.
All hoses and fittings must be the correct
size and tightly fastened. Refer to Chart 1
for minimum sizes.
that are damaged or deteriorated.
pull the hose to move the tool or a
compressor. Keep hoses away from
heat, oil and sharp edges. Replace any
hose that is damaged, weak or worn.
Option 1: Individual components
Filter Regulator
Option 2: 3 piece combo
Filter, Regulator, and Lubricator
www.campbellhausfeld.com
Tool Air Consumption
Less than 9 SCFM @ 100% usage
9 to 34 SCFM @ 100% usage
Greater than 34 SCFM @ 100% usage
Chart 1 - Suggested minimum hose diameter to
use based on 50 ft length hose and continuous
SCFM rating of tool. The use of fittings and longer
hose may require a larger diameter hose to be
used.
Lubricator
CL157500AV
Hose ID
1/4 inch
3/8 inch
1/2 inch
Do not use
hoses or fittings
Never carry a tool
by the hose or
3