How To Check Nanoe™ X Connection - Panasonic nanoe CZ-CNEXU1 Instrucciones De Instalación

How to Check nanoe™ X Connection
 Check the nanoe™ X connection in the "Detailed settings" of remote controller.

1. Install the indoor unit as described in the installation instructions attached to the indoor unit.
2. Install the remote controller to the indoor unit which is adaptable to the nanoe™ X function.
3. Connect the power wire provided with the earth leakage circuit breaker to the indoor unit and
supply electricity.
4. With the remote control display blinking "Assigning", press
simultaneously for 4 or more seconds to show the "Maintenance func".
5. Select "8. Detailed settings" by using
press . "Detailed settings" menu is displayed.
6. With using
"Set data". Press
"Unit no.".
7. With using
8. The nanoe™ X operation is normally activated as long as "0000" does not appear under "Set
data". If "0000" appears, the nanoe™ X connection is not recognized.
<In case of "0000">
1. Switch Off the earth leakage circuit breaker.
2. Try to unplug the connector of nanoe™ X kit from the PCB. Then plug it in again.
3. Switch On the power of earth leakage circuit breaker again.
4. Check again the above steps 4 to 8. The nanoe™ X operation is normally activated as long
as "0000" does not appear under "Set data".
If "0000" appears, there is possibly something wrong with the unit.
Contact the dealership you purchased.
/ , select "Unit no.", "Code no." or
with showing "ALL" under
/ , select "9F" under "Code no.".
+
/ and
+
E
7
NGLISH