Kohler STERLING 6300 Serie Guia De Instalacion página 4

Measure
here.
Angled Base
1. Determine the Door Configuration
IMPORTANT! Separate assembly instructions may apply depending on which pivot configuration is
chosen. For purposes of these instructions, a "left hinge" installation is shown.
IMPORTANT! Install the pivot side of the door on the side opposite the showerhead.
Determine whether the door will pivot on the right or left side.
Make sure the door can swing freely in the chosen configuration.
2. Measure and Cut the Bottom Track
IMPORTANT! Risk of product damage. If your shower has a curve in the corners where they meet the
sidewalls, be sure to measure from wall to wall above the curves. Failure to measure above the curve or
angle could result in the bottom track being cut too short.
Carefully measure the width (distance D) of the finished opening.
Refer to the roughing-in sheet to confirm that the door will fit in the finished opening.
Subtract 2-3/16" (5.6 cm) from dimension "D." The resulting dimension is the bottom track cut
length.
NOTE: If dimension "D" is falls in a range that can be either with or without the filler jamb, use the filler
jamb in your installation.
File the rough edges smooth where the bottom track was cut, taking care to avoid damaging
finished surfaces.
NOTE: If there are curves where the sidewalls meet the threshold, contour the wall jamb edges to match
the curves.
1019156-2-F
Measure distance
"D" above curves in
the corners.
Important: Measure carefully. If your walls are curved or angled, measure
above the curve or angle. Failure to do so can result in an
improperly cut bottom track and can void the warranty.
D
4
Measure
here.
Curved Base
Sterling