Skil PM4912B-00 Manual Del Propietário página 28

The mower stops
while mowing.
The mower does not
mulch properly.
There is excessive
vibration.
The handle-locking
clamps cannot be
closed in position.
Short running time
of the mower with
included battery.
28
1. The battery packs are depleted.
2. Mower is in overload condition.
3. Mower deck is clogged with grass
and debris.
4. One or both battery packs, or the
mower are too hot.
5. The side rail is retracted a little by
the pushing force applying on the
handle.
1. Wet grass clippings are sticking
to the underside of the deck.
2. The mower is set to cut too much
grass at once.
1. The cutting blade is loose.
2. The cutting blade is unbalanced.
3. The cutting blade is bent.
1. The side rails are not fully
extended.
1. Grass conditions and cutting
height setting will greatly affect
the battery run time.
1. Charge the battery packs.
2. Raise the cutting height or
slow down the mowing.
3. Turn off the mower and
remove the battery pack
from the mower. Unclog
the mower deck. Raise
the cutting height, or cut a
narrow swath.
4. Turn off the mower and
remove the battery packs
from the mower. Allow
the battery packs and the
mower to cool down.
5. Unlock the clamps. Fully
extend the side rails and
lock the clamps again.
1. Clear accumulated grass
and wait until the grass dries
before mowing.
2. Raise the deck to a higher
cutting height setting.
1. Tighten the blade bolt.
2. Balance the blade following
the instructions.
3. Replace the blade.
1. Fully extend the side rails,
then lock the clamps.
1. Raise the blade height and
slow your pace to reduce
the cutting load.