Operating Instructions - Powerplay HOTROD HR230HR24PPLSEZ Instrucciones De Ensamblaje, Cuidado Y Uso

Before Starting Engine
1. Read and understand the operation manual and
appropriate safety information before operating the
power washer.
2. Ensure that the oil is at an adequate level, and that there
is fuel in the fuel tank.
3. Assess the integrity of the power washer and ensure
that there is no physical damage or leaks on the
machine, or breakage on the high pressure hose.
4. Connect a strong source of water to the machine, along
with a clean filter, and no excess air in the machine.
5. Set the unit on level ground, in a clear work area.

Operating Instructions

Starting Power Washer
1. Always set the engine throttle lever to the full open (rabbit)
position. Pressure washer is not designed to run at partial
or low throttle.
2. Move fuel valve to ON, move choke lever to CLOSE and turn
engine switch ON.
3. Discharge any pressure from the spray gun.
4. Securely place foot on footpad when pulling the recoil.
5. Slowly pull the starter grip handle until tension is apparent.
Then quickly pull with force to start engine.
6. DO NOT release the starter grip handle immediately when
engine starts, GENTLY ease the handle back into place.
7. After the engine has started, gradually adjust the choke
lever to the"OPEN" position as the engine continues to run.
If the engine starts to stammer, revert the choke lever to the
"CLOSE" position, then back to the"OPEN" position.
DANGER
Asphyxiation. Running engines produce carbon
monoxide, a colorless, odorless, poisonous gas.
Carbon monoxide, if not avoided, will result in death
or serious injury.
• Fluid Injection. This machine produces high pressure fluid
streams that can pierce skin. Fluid injection will result in
death or serious injury.
WARNING
Risk of Fire. Hot surfaces could ignite combustibles,
resulting in fire. Fire could result in death or serious
injury.
• Vision Loss. Eye goggles are required to be worn when
using this machine. Failure to wear eye goggles could
result in permanent vision loss.
• Recoil Hazard. Recoil could retract unexpectedly if water
pressure is not properly relieved from pump, creating
kickback. Kickback could result in death or serious injury.
NOTE: DO NOT run the machine without a proper water
connection. Failure to connect a water source will damage
the pump, and void warranty.
If the engine fails to start, relieve any pressure in the spray
gun before trying again.
If the engine fails to start after six pulls, move the choke lever
to the "OPEN" position, and repeat steps 4 through 7.
12