Troubleshooting Guide; Technical Specifications - Forza SL-1501UL Manual Del Usuario

UPS mode LCD
Battery mode
The icon is displayed when
battery level is low
Overload in battery
mode
The icon is displayed on the
screen

7. Troubleshooting guide

If the UPS system does not operate correctly, use the table below to troubleshoot the problem.
Fault condition
The output is short circuited
Overload fault
Overcharge
Defective or severely
discharged battery
High output voltage
Over-temperature
For further assistance, please contact us at tech@forzaups.com
Description
When the UPS is in battery mode and
battery voltage begins to dwindle, the unit
will beep once every 10 seconds. Also when
the LCD is touched, the information will be
displayed in the following order:
1. Output voltage
2. Input voltage
3. Load level
4. Battery capacity
When the UPS is overloaded, the unit
beeps every 0.5 second to warn about
such condition
LCD Solution
Disconnect short-circuited
loads and restart the UPS
Remove all connected loads
and restart the UPS
Call for technical assistance
immediately
Please replace the battery
Call for technical assistance
immediately
1. Turn off and wait for the unit
to cool
2. Or remove excessive loads
and wait for the unit to cool

8. Technical specifications

MPN
General
Capacity
Input
Nominal voltage
Voltage range
Frequency
AC plug style
Output
Nominal voltage
Frequency
Frequency stability
Waveform
Total outlets
Full battery with surge
protection outlets
Surge protection only
outlets
USB management
Battery
Battery type and quantity
Backup time
Recharge time
Voltage regulation
Voltage regulation
Boost
Buck
Frequency regulation
Automatic frequency
selection
Frequency regulation
Transfer time
Low line transfer to battery
High line transfer to battery
Alarms/Indicators
Visual indicators
Easy to read touchscreen LCD with blue backlight that displays input
voltage, output voltage, battery capacity, load level, and UPS status
Audible tone
Protection
Full protection
Voltage regulation, overload, discharge and overcharge protection
Joules
SL-1501UL SL-2001UL
1500VA / 900W 2000VA / 1200W
120V
81-145VAC
45-65Hz (autosensing)
NEMA 5-15P
120V +/- 10%
50/60Hz
+/- 1Hz battery mode
Modified sine wave
8 (NEMA 5-15R)
6
2
Included with ForzaTracker software
12V / 9Ah (2)
64 min ** 78 min **
6 hours to 90% after complete discharge
145V +/-5%
Vin x 1.18
Vin x 0.85
Included
2-4ms
81VAC
145VAC
Battery mode: Sounds every 10 seconds
Low battery: Sounds every second
Overload: Sounds every 0.5 second
Fault: Sounds continuously
1000J