Speedaire 1WD21 Instrucciones De Operación Y Manual De Partes página 8

Speedaire
Operating Instructions & Parts Manual
Speedaire
Two-Stage Air Compressor Pump
Guide To Maintenance
For Service call 1-888-303-1344.
All request should include model
E
number and serial number. To
N
obtain reliable and satisfactory
G
service, this unit requires a
L
consistent preventive
maintenance schedule.
I
Maintenance schedule forms
S
are included to aid in keeping
H
the proper records.
performing any
maintenance function,
switch main disconnect
switch to "off" position to
assure no power is
entering unit. "Lock out"
or "tag out" all sources of
power. Be sure all air
pressure in unit is relieved.
Failure to do this may
result in injury or
equipment damage.
Daily Maintenance
1. Check oil level of compressor.
Add Speedaire recip lubricant
as required. See "Compressor
Oil Specifications" Section.
NOTE: Do not mix oil type,
weight, or brands
For Service and Warranty, Call: 1-888-303-1344.
®
5 & 7.5 HP
2. Drain moisture from tank
by opening tank drain
valve located in bottom
of tank. Do not open
drain valve if tank
pressure exceeds 25 PSIG.
3. Turn off compressor at
the end of each day's
operation. Turn off power
supply at wall switch.
Weekly Maintenance
1. Clean dust and foreign
Before
matter from cylinder
head, motor, fan blade,
air lines, intercooler and
tank.
2. Remove and clean intake air
filters.
exceed 15 PSIG nozzle
pressure when cleaning
element parts with
compressed air. Do not
direct compressed air
against human skin.
Serious injury could result.
Never wash elements in
fuel oil, gasoline or
flammable solvent.
3. Check V-belts for tightness.
The V-belts must be tight
enough to transmit the
necessary power to the
compressor. Adjust the
V-belts as follows:
a. Remove bolts and
b. Loosen mounting
d. Check the alignments
Do not
e. Tighten mounting
f. Re-install guard and
without belt guard in place.
Removal will expose rotating parts
which can cause injury or
equipment damage.
8
1WD21
guard to access
compressor drive.
hardware which secures
motor to base. Slide
motor within slots of
base plate to desired
position.
c. Apply pressure with
finger to one belt at
midpoint span.
Tension is correct if
top of belt aligns with
bottom of adjacent
belt. Make further
adjustments if
necessary.
of pulleys. Adjust if
necessary.
hardware to secure
motor on base.
secure with bolts.
Never operate unit