Scenarios
6.2 Activating the other set scenarios.
Main menu Scenarios
Select the scenario to activate using the and buttons and press Select (button I) to confirm.
Lastly, press Back and Menu in sequence to exit and go back to the Main Menu.
6.3 Creating a new scenario.
Scenarios are normally created by the installer or by a user he has enabled.
Main menu Scenarios
Using the push-buttons and select Scenario Management and press Select (button I on the
control panel) to confirm.
New Scenario Select
Enter the name you want to give to the scenario using the push-buttons
G), (button H) and
Car
Press
(button L) to save the name.
Name
Using the push-buttons and select Associated Groups and press Select (button I on the control
panel) to confirm.
Added Group Select
The control panel will display a list of all the groups (that is to say the functions) that have been con-
figured.
Using the push-buttons and croll through the list (for instance, Thermostat 01 Lounge, Roller
Shutter 01 Bedroom, Light 01 Study, etc.) and press Associate on the ones (and only those!!) that
you want to add to the scenario; the associated devices will be marked with
Press Save.
(On pressing Remove, the selected GROUP will be removed from the scenario while Ass.All., Rem.
All., associates and removes all the device groups).
Now, all the LEDs of the push-buttons of the associated GROUPS will begin to blink and it will be
necessary to set them so as to duplicate precisely the scenario you want to obtain.
For example, if a light is already lit and in the scenario you want to keep it on, press the push-button to
switch it on (as if at that moment it were off); on the contrary, if a light is lit and you want to associate
it off in the scenario, press the button to switch it off.
In the case of the dimmer switch, you need to select the desired brightness with the push-buttons.
(press button C on the control panel).
(press button C on the control panel)
(press button I of the control panel)
(button I).
(press button I on the control panel).
(press button F).
Setup
Normal scenario Select
(button F) , (button
A.a
.
49
49