Extel WEVPSF 659 Instrucciones De Uso E Instalación página 33

Installing the control box board
The box must be installed firts, Follow the instructions below :
1• Use the 6-conductor cable for the cabinet/panel link and 2 wires (F) for the cabinet/electric strike link. The
cable (for connecting the roadside panel) must first be routed through a hole that goes from one side of the
post to the other. The connection (F) must to connect the other two wires to the lock or electric strike plate and on
the connection «LOCK» of control box (fig.4').
2• Once the box is installed keep the antenna as far away as possible from all metal surfaces, sources of interfe-
rence and obstacles between the box and your home, (in particular, no leaves or branches should touch it). For
best results, it should also be placed high enough (approx. 1.6 m above ground level) and be vertical.
N.B. : If the transmission is of insufficient quality, use the 2 m cable supplied to find a better position for the
antenna.
Once you have found the ideal location :
1• Remove the cover from the box by unscrewing the 6 cross-head screws (H) (fig. 5).
Warning : do not directly touch the electronic circuitry (see comment chapiter safety instruction : Important -
p 3)
2• Fasten the box with two screws (J) at the top and bottom (fig. 6), The antenna is at the top right.
3• Remember to route the connecting cable for the roadside panel through the hole in the post first.
N.B. :
Do not install an antenna other than the original one supplied
Warning :
Never insert the batteries before installation is completely finished.
fig.4
H
F
fig.5
H
CFI EXTEL WEVPSF 659 - 10/2011
GB8
fig.4'
LOCK
+ -
fig.6
J
I
Installing the roadside panel
Tip : we recommend running the cables (for the roadside panel and the electric strike plate) through a conduit to
protect them from impacts and the elements. To avoid oxidation and poor contacts, , do not trim the excess from
the 6-conductor cable. Instead, wind it around itself between the post and the electronic box.
1• Remove the cross-head screw (A)
2• Tip the roadside panel (B) toward the front and dislodge it from the bottom.
3• Using the 3 screws (K), mount the box (C) flush with the wall so that the slot (D) is facing the cable (E)
4• Fit a silicone seal behind the Rain shield (C) to protect it from water running down the wall.
5• Pass the connecting cable
6• Connect the 6 wires (E) to the back of the roadside panel
7• Check the orientation of the camera (G) (fig. 8).
VIDEO ( yellow ) GND ( black ) SPK (brown) MIC (white) KEY (green) VCC ( red )
8• Put the roadside panel back in place and fasten with the screw (A).
fig.7
C
K
B
A
fig.8
J
(fig. 7 / 8 / 9)
F
E
D
Warning : to avoid condensation, place the
fig.9
seal only along the top of the box (C).
Silicone seal
CFI EXTEL WEVPSF 659 - 10/2011
B
A
K
C
E
D
A
G
VIDEO : yellow wire MIC : white wire
GND : black wire KEY : green wire
SPK : brown wire VCC : red wire
GB9