Mounting The Antenna - RCA ATTIC/OUTDOOR COMPACT DESIGN Guía De Uso

4. Attach the UHF dipoles to the balun housing.

Mounting the antenna

1. Mount the antenna bracket to a flat surface.
Use wood or masonry screws (not included) to mount the antenna
bracket to a flat surface.
2. Insert the mast into the antenna bracket.
Insert the J-pole antenna mast into the opening on the antenna
bracket.
Insert the M6x25 carriage bolt through the two holes next to the
opening on the antenna bracket. Screw the M6 large wingnut onto
the M6x25 carriage bolt until the J-pole is held securely in place.
4
Place one of the UHF dipole onto
one of the posts at the front of
the balun housing. Screw a wing
nut on top.
Repeat with the other UHF dipole
on the other post at the front of
the balun housing.
Pieces used in this step:
(2) UHF dipoles
(2) M4 wingnuts
Pieces used in this step:
(1) Antenna bracket
(4) Wood screws (not included)
Pieces used in this step:
(1) J-pole antenna mast
(1) M6x25 carriage bolt
(1) M6 large wingnut