nurse MULTI Instrucciones página 11

MULTI
GB
Assembly instructions
Opening the walker
1
Open the walker by lifting the tray to its highest position. Gently push down on the top section to make
sure it has locked into position. Fig. 1
Attaching the rear wheels
2a
Insert the rear wheel into the moulded socket in the direction indicated by the arrow. Then press firmly until
it clicks securely into place. Fig. 2a
Attaching the front wheels
2b
Insert the castor wheels into the moulded socket in the direction indicated by the arrow. Then press firmly
until they click securely into place. Fig. 2b
Fitting the seat unit
3
Place the seat pad on the top section.
Press downwards firmly until it is securely fastened on the top section. Fig. 3
Attaching the activity tray
4a
Two AA alkaline batteries are needed for the activity tray (not included). Insert the batteries in the activity
tray. Fig. 4a
Unfold the walker and put the activity tray in place. Push the locking keys on the side of the walker tray
4b
upwards and turn them to fasten the activity tray to the walker. Fig. 4b
5a Lowering the rocker
Press the two buttons (a) in the direction indicated by the arrow and turn 90 degrees to the side; then
5b
release the lower part. Make sure that it is correctly in place. Fig. 5a Fig. 5b
6
Fit the footrest on the bottom tray. Fig. 6
7 Attaching the octopus and butterfly
Align the octopus and the butterfly with the slots in the tray front and insert the tabs on the toys into the
slots in the tray and turn them to the right until they are locked into place. Fig. 7
8 Attaching the activity bar
Align the bee and lollipop bar with the slots in the back of the tray and turn them to the right until they are
locked into place. Fig. 8
Pushing the walker
9
Detach the activity bar. Align the handlebar with the slots in the rear tray. Fit the locking cover onto the
protruding end of the handlebar and turn it to fasten the handlebar to the walker. Fig. 9
Pull the red safety catch upwards and then push the white release tab inwards. The tray can now be
10
lowered to one of the three height positions or fully folded for storage. Fig. 10
11 Fastening the seat when used as a baby walker
The lock marked with a "cross" is found underneath the top tray, press the long vertical bar forward and
insert it into the slot in the seat structure to fasten it in place; this means it cannot turn round. Fig. 11
MAINTENANCE
Keep the metal parts clean and dry to prevent rusting. Grease the mobile parts and mechanisms
regularly with a silicone based spray. Do not use oil or grease. To clean the plastic parts just use
mild detergent and warm water. Do not expose the upholstery to sunlight for long periods of time.
The upholstery may be taken off for washing.
1816,00 MULTI ins 6 idiomes.indd 11
INSTRUCTIONS
11
28/01/15 12:43