Date/Time Settings - GPE Vendors DRX Manual Tecnico

A characteristic of the board is that to alternate the previous
GB
sequence of the status scheme with a certain number of "Spots".
40
These are full screen graphic images which can be designed
using any graphic program on a PC. You will need to create a fi le
for each Spot of the BITMAP type, monochrome with resolution
128x64 and download to the board using the relevant software on
a PC with a normal serial cable RS232. At this point it is enough
to program the number of seconds of visualization requested for
each Spot. Up to 8 Spots can be downloaded to the board and kept
at disposition for activation on particular occasions. Available in
this menu are other parameters such as an identity number for
the machine and a communication address for the programming
portal (for the management of more than one machine with the
same PC or other method of external supervision).
The "Machine model" parameter must be programmed depending
on the particular machine so that the board can manage in the
appropriate way all specifi c functions.
The "Operator Code" permits a number to be programmed to
be used as a password for access to the machine menu. A code
equal to 0 deactivates the request for the password whilst it is
possible to insert a number using all 10 numbers from 0 to 9.
When the password is requested the keypad can be used to digit
the value directly. The keys from 1 to 5 have a second function
when the "Shift" (7) key is pressed:
Note: entering the principal service menu with the appropriate
key when a password has been programmed, the introduction of
the code is requested. Here there are two possibilities. Pressing
directly "OK" (8) enters the principal menu without password and
in this case certain menus will not be accessible without later
inserting the password. Instead, inserting the correct password
using keys "1"-"5" and "Shift" all menus will be accessible up to
exiting the service menu.
"WATCH SETTINGS" MENU
•

Date/time settings

• ON/OFF prog. setting
"Date/time setting" allows the regulation of the date and current
time on the machine clock. This clock is used for various machine
functions. Apart from visualizing in the pause between vends, the
clock is used to update the expiry of the products (when used),
to manage the turning on and off of the different parts of the
machine according to certain programs and to provide the data-
logger records of the time/date information on particular events.
"ON/OFF prog. setting" contains a list of 16 programs to turn on
and off the cooler group, the display case illumination and the
display. If the illumination has been turned off by a program,
it is possible to momentarily turn it back on again pressing
any key on the keypad and thus allowing a vend. Each on/off
program consists of a total of 8 fi elds of which the fi rst 7 identify
a particular condition of time/date whilst the last is of the on/off
status desired departing from that time/date. The programs are