Connecting A Computer Or Component Video Source - Connecting A Computer Or - Toshiba 27WL56 Serie Manual Del Usario

Connecting a computer or
Before connecting any external equipment, turn off all main power switches. If there is no switch
remove the mains plug from the wall socket.
Computer
Connect the PC cable from the computer to the PC
terminal on the back of the television.
Press the B to select PC mode.
The following signals can be displayed:
VGA: 640 x 480/60 Hz (VESA 480-60)
SVGA: 800 x 600/60 Hz (VESA 600-60)
XGA: 1024 x 768/60 Hz (VESA 768-60)
IMPORTANT NOTE: The 27WL model will display
XGA but it will not be to the VESA standard.
PLEASE NOTE:
Some PC models cannot be connected to this
television.
An adaptor is not needed for computers with a DOS/V
compatible mini D-sub 15p terminal.
A band may appear at the edges of the screen or parts
of the picture may be obscured. This is due to the
strength of the signal, it is not a malfunction.
component video source
the back of your television
Audio cable from PC or
component video audio
source to television
(not supplied)
Conversion adaptor if required (not supplied)
Mini D-sub
15p connector
RGB PC cable
(not supplied)
When PC input mode is selected some of the
television's features will be unavailable e.g. Manual
setting in the SET UP menu, Colour, Tint, DNR and
Black Stretch in the Picture settings menu.
Signal information for Mini D-sub 15p connector
Pin assignment
for RGB/PC
terminal
Pin. No. Signal name
1
2
3
4 NC (not connected)
5
6
7
8
7
Mini D-sub
15p connector
Component video connector (not supplied)
Pin No. Signal name
R (P *) 9
R
G (Y*) 10
B (P *) 11
B
12
NC 13
Ground 14
Ground 15
Ground
* Component video
NC
Ground
NC
NC
H-sync
V-sync
NC