External Connections - TLS Range M 100 Manual De Instrucciones

Volume control
Control the volume of the cassette drive, the CD drive and external
devices with the TAPE/CD button. Turn the volume control to the right
to set the maximum volume and in the same way to the left to turn the
volume down.
The mic volume controls MIC 1 and MIC 2 regulate the microphone
volume. Turn the volume control to the right to set the maximum
volume and in the same way to the left to turn the volume down.
The channel control BALANCE controls the balance between the left
and right channels for an optimal stereo effect. Turning this to the right
lowers the volume of the left channel and vice versa. Under normal
circumstances, leave the control on the middle setting.
Tone balance
The tone controls BASS and TREBLE allow a lowering or raising of the
low and high tones.
Set the tone on the TLS devices according to the acoustics in the
room, or as required. As soon as the maximum value has been
reached using the control TAPE/CD, playback distortions can occur
which could damage the loudspeaker system.
Note: Playback distortions can damage the loudpeaker. Do not
operate the device for any length of time when distortions
occur. Lower the total volume and stop the distortion.

External Connections

MIC 1 and MIC 2
Via the MIC 1 and MIC 2 connections wired microphones can be
connected to the device with a 6.3 mm jack plug.
LS-OUT
The active TLS amplifier M 100 LS PLus can be connected via the LS-
OUT connection. The LS-OUT connection enables stereo operation.
Connect both devices before switching them on.
Audio IN
An external audio source can be connected via the Audio IN
connection to record this onto a cassette, for example.
30
Operation Manual
Status 11/03