Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
FEATURES
Voltage
Frequency
Power Rating
Heigth
Width
Depth
Net Weight
Gross Weight
Maximum Cutting Height
Maximum Cutting Width
3. INSTALLATION AND PRE-OPERATION
3.1 Placing
The equipment must be installed over a firm and level
working surface, in a 700 mm x 800 mm area.
3.2 Electrical Installation
The power plug has 3 pins the middle pin is the ground . All
the 3 pins must be properly connected.
3.2 Pre-Operation
Before to use the equipment all the parts which could get
into contact with the product to be processed shall be
washed with water and neutral soap ( see item 5 CLEANING).
4. OPERATION
4.1 Starting
To start the equipment follow the below instructions:
- Make sure all the protections and the door are in due place
and the door is closed;
- Plug the equipment to the electric network;
-Press the ON/OFF Switch # 13 (Pic.02) on position "I" ON
the equipment will start.
4.2 Operation Procedures
4.2.1 Door
The Door #02 (Pic. 01) shall be closed as long as the
equipment is in use.
4.2.2 Thickness Guide
To obtain several same thickness slices adjust the Thickness
Guide #11 (Pic.01) as desired. That for turn the thickness
guide handle counter clockwise getting the guide free, then
place the Thickness Guide at the desired thickness and tight
the Thickness Guide Handle turning it clockwise.
4.2.3 Blade
The Blade must be installed with the teeth turned
towards the front side of the machine and with the points
downwards.
To regulate (stretch) the Blade #10 (Pic.01) turn clockwise
the Blade Tension Regulator Handle # 01 (Pic.01) until it
stops.
UNIT
SF-282
V
110 or 220
Hz
50 or 60
CV
2
mm
1675
mm
800
mm
835
kg
75
kg
102
mm
280
mm
390
4.2.4 Blade Guide
With the equipment switched OFF, turn the handle #12
(Pic. 01) counter clockwise to get free the Blade Guide #04
(Pic.01). Then adjust the Blade Guide to have it no more
than the height of the product to be cut and tight the Handle
# 05 (Pic.01).
4.2.5 Lower Wheel
The Lower Wheel# 06 (Pic. 01) is assembled on the lower
bearing shaft.
4.2.6 Upper Wheel
The Upper Wheel # 03 (Pic. 01) has in its frame the shaft and
the bearing.
Before to start the machine
Push the Movable Table # 09 (Pic. 01) totally to the front
side of the machine.
Place the product to be cut on the Movable Table.
Choice the slices thickness and adjust the Thickness Guide
# 11 (Pic.01).
Adjust the Blade Guide # 04 (Pic. 01) to no more than the
height of the product to be cut.
Stay in front of the machine to have a front sight of the
Blade.
Start the Machine
To start the machine turn the ON/OFF Switch button "I"
(ON).
Catch the Movable Table with the left hand and push against
SL-282
SF-218
110 or 220
110 or 220
50 or 60
50 or 60
2
1,5
1675
1600
800
700
835
800
75
73
102
92
280
260
390
270
Picture 02
SL-218
110 or 220
50 or 60
1,5
1540
630
645
56
75
210
230
3
Publicidad
Tabla de contenido
