Add - Remove The Clip-On Face Cover - Lofrans 74317 Manual De Instalacion Y Uso

3.2 Add – Remove the Clip-on Face Cover
6
Fig.2
Fig.3
Fig.4
TOUCH PANEL UP DOWN
• Make sure that the rubber seal is placed
on the base column.
• Wire and/or plug the unit following the
wiring diagram (see chapter 5)
• For the correct
positioning, ensure
that the terminal block
connector is to the
lower side behind the
Lofrans' Touch Panel
(see Fig.3)
• Fasten base unit with the four
fixing screws provided with the
device package (see Fig.2)
• Only when totally finished and satisfied
with the wiring and positioning of the unit,
clip-on the face panel/cover. Lofrans' logo
must be on the left side of the Touch Panel,
exactly as shown in Fig.4
• Make sure that the transparent waterproof
button covers are placed properly.