Wiring Diagam; Warranty Conditions - Lofrans 74317 Manual De Instalacion Y Uso

5 WIRING DIAGRAM
ALWAYS DISCONNECT THE BATTERY PRIOR TO INSTALLATION
The wires must have a cross section size of 1.5 mm².
Install a 5 A (ampere) fast safety fuse on the positive (+) wire of the battery. Do not use the voltage
generated by the engine battery set to provide power.
If possible, place the back side of the device in a dry place to protect it from contact with water or
moisture.
PIN SIGNAL
1 - battery
2
+ battery
3 DOWN command
4 UP command

6 WARRANTY CONDITIONS

Lofrans' warrants that in normal use and observing the maintenance schedules, the product is
covered by warranty for a period of 2 years from the date of purchase by the original purchaser,
without prejudice to the conditions, limitations and exceptions listed below. Any product that proves
defective in normal use during said period shall be repaired or replaced, as Lofrans' chooses.
8
OPTIONAL
EXTERNAL
REMOTE
SWITCHES
Fuse 5A
CONTROL BOX
TOUCH PANEL UP DOWN
Switch
+ Battery
- Battery