Battery Change - Zamel extra free P-257/4 Guia De Inicio Rapido

OPERATION
After pressing the push-button the remote control sends a signal on
868 MHz which controls EXTA FREE receivers. Device programming
procedure (adding a transmitter to the transmitter's memory) is
described in manual instruction of particular EXTA FREE system
receivers.
The range (up to 250 m depending on a receiver) can be changed by
means of a retransmitter or few RTN-01 retransmitters.

BATTERY CHANGE

Battery discharge status is signalled by several LED red diode
flashes during transmission time.
1. Remove the screws from the bottom part of the remote control.
2. Remove the upper cover with the silicon keyboard.
3. Remove the battery from the latch.
4. Mount a new battery. Watch battery polarisation marked on the
latch. Wrong battery mounting may cause device damage.
5. Place back the top cover with the keyboard and tighten the screws.
CAUTION: While changing the battery, it is suggested to press any
of the buttons for about 5 seconds before putting it into a latch.
Next press transmission button several times to check its opera-
tion. If the transmitter does not work properly repeat the battery
change procedure.
SUBSTITUTING THE BATTERY WITH ANY BATTERY OF INCOR-
RECT TYPE MAY CAUSE AN EXPLOSIVE HAZARD.
DISPOSE OF USED BATTERIES AS STATED IN THE MANUAL.
COOPERATION AND OPERATING RANGE
Symbol
RNK-02 180 m 200 m 200 m 200 m 200 m 250 m 250 m 250 m 180 m 250 m
RNK-04 180 m 200 m 200 m 200 m 200 m 250 m 250 m 250 m 180 m 250 m
P-256/8 230 m 250 m 250 m 250 m 250 m 300 m 300 m 300 m 230 m 300 m
P-257/4 (2) 180 m 200 m 200 m 200 m 200 m 250 m 250 m 250 m 180 m 250 m
RNМ-10 230 m 250 m 250 m 250 m 250 m 300 m 300 m 300 m 230 m 300 m
RNP-01 160 m 180 m 180 m 180 m 180 m 200 m 200 m 200 m 160 m 200 m
RNP-02 160 m 180 m 180 m 180 m 180 m 200 m 200 m 200 m 160 m 200 m
RNL-01 160 m 180 m 180 m
RTN-01 200 m 200 m 200 m 200 m 200 m 250 m 250 m 250 m 200 m 250 m
RCR-01
160 m 180 m 180 m
RXМ-01 230 m 250 m 250 m 250 m 250 m 300 m 300 m 300 m 230 m 300 m
* - 1-channel transmitters do not cooperate with roller blind controllers.
-* -* 200 m 200 m 200 m 160 m 200 m
-* -* 200 m 200 m 200 m 160 m 200 m