Technical Data; Fuel Requirements; Technical Specifications; Fuel Specifications - Truper PRETUL MOT-4520P Manual Del Usuario

Technical data

Code
Description
Bar Length
Chain Pitch
Chain Gauge
Drive Sprocket Wheel
Motor Cylinder Capacity
Motor Rated Power
Maximum Motor Speed
Chain Speed
Fuel Tank
Oil Tank
Vibration
Work Cycle

Fuel requirements

• The chainsaw is built with an air-cooled, 2-stroke motor using unleaded gasoline high quality self-mixing oil with fuel stabilizer
specified for air-cooled 2-stroke motor.
• The motor is certified to function with unleaded gasoline for vehicles with an 87 ([R+M]) octane-rating or higher.
• Do not use any type of pre-mixed gasoline with oil purchased in gas stations, like the one fit for motorcycles.
• DO NOT use automotive oil, nor outboard 2-stroke motor oil.
• The mix ratio shall be 40 parts gasoline per 1 part oil (ratio 40:1). Prepare the mix in a gasoline approved container. Always
mix thoroughly before pouring in the motor tank.
Do not use fuel mix that has been stored more than 7 days. Mix only small amounts.
CAUTION
Never smoke near fuel or the area where gasoline is being filled up nor where the mix with
WARNING
oil is being prepared or when operating the chainsaw.
Use the cap of
mix. Mix 5 capfuls oil with each liter gasoline.
1
L
1 liter
Gasoline
To make the useful life of the motor las longer use
* 1 gallon = 3,78 liters
MOT-4520P
26015
20"
40 minutes rest per each tank consumed.
oils ** ACT-2T-4 or ACT-2T-16 as a measure to prepare the
A wrong mix can cause the machine to throw-a-rod,
causing costly repairs!
+
5 capfuls oil
** Not included
MOT-4518P
Chainsaw
0.325"
0.05"
with 7 (0.325") sprockets
45 cc
2.2 HP
12 000 RPM
3 937 ft/min
17 oz
8.4 oz
front handle 3.5 m/s
2
rear handle 7.7 m/s
2
Maximum 5 hours daily.
=
proportion
40:1
synthetic oil for 2-stroke motors.
26017
18"
Mix
3
ENGLISH