Pre-Use Preparation And Assembly; Part Identification - Nostalgia Electrics DOUGH NU-MATIC Manual Del Usuario

ENGLISH
IMPORTANT SAFEGUARDS
10. Keep hands and utensils out of the unit while operating to reduce the risk of
severe injury to persons or damage to the DOUGH NU-MATIC Automated
DONUT MAKER™. A spoon or tongs may be used to manually flip or remove a
trapped donut out of the oil, but only when the donut maker is not running.
11. DO NOT place on or near a hot gas or electric burner, or in a heated oven.
12. Before plugging your unit into the main electrical supply, make sure the voltage
corresponds to that indicated on the maker's nameplate.
13. Extreme caution must be used when moving the DOUGH NU-MATIC Automated
DONUT MAKER™ with liquids.
14. Do not use this appliance for other than intended use.
15. The cooking oil inside the DOUGH NU-MATIC Automated DONUT MAKER™
will be extremely hot - use caution.
16. A unit that is plugged into an outlet should not be left unattended.
17. Make sure the donut slide, collecting bin and bin drainage pan are in place and
properly attached before turning on the DOUGH NU-MATIC Automated DONUT
MAKER™ base unit.

PRE-USE PREPARATION AND ASSEMBLY

Your DOUGH NU-MATIC Automated DONUT MAKER™ comes fully assembled when
removed from the box. The collecting bin and drainage tray will be the only loose parts
included.
Prepare for first use by thoroughly washing the dough hopper, donut slide, collecting bin
and drainage tray in warm sudsy water and thoroughly dry. DO NOT put the motor base in
water. To clean the motor base when needed, use a damp cloth to wipe the exterior, and
then dry off with a clean, non-abrasive towel. (See part identification in breakdown shown
below).
1. Unlatch and rotate the motor dispenser head counter clockwise, exposing the
dough hopper. Remove the dough hopper for washing by lifting up and out of the
notched receptor hole it sits in.
2. Remove the donut slide located on end of the DOUGH NU-MATIC Automated
DONUT MAKER™ for washing. To remove the donut slide, place thumb and first
finger on either side of the slide and pull out and away from the unit.

PART IDENTIFICATION

BREAKDOWN
1. Motor Dispenser Head
2. Activation Motor Switch A
3. Heat/ Motor Switch B
4. Oil Drainage Control Box C
5. Bin Drainage Pan
6. Donut Slide
7. Safety Windows
1
2
3
NOT SHOWN: Collecting bin with drainage tray.
2
4
7
6
5