GLOBBER GO BIKE Manual Del Usuario página 8

Keep the instructions for future.
NF-EN-71
Warning! Protective equipment should be worn. Not to be
used in traffic.
Please carefully read the instructions before assembly and
use the toy.
Be careful when unpacking and assembling the product.
This toy must be assembled by a responsible adult.
Remove all the parts which are not necessary for play
before giving the toy to your child.
General instructions of use
• Prior to use, make sure that the toy has been assembled
properly. Check the GO BIKE before the child rides to
determine if there are any potentially hazardous parts or
conditions.
• Children should be supervised by adult while riding this
GO BIKE. Special care should be taken to instruct children
in safe riding.
• Do not use on the public highways, examples of safe riding
area: To be used on flat and no gravel areas (playground,
Public Square)
• Do not use this toy near a staircase, on a slope, on a road
or on a wet surface.
• More mobility child grows, the more potential hazards
increase. At home, be sure to remove frames or mirrors
hung too low and could break, and any object that could
fall in the event of impact. Corner table can also be a
danger.
• Do not allow more than one rider on the GO BIKE at
a time.
8
• Be sure the child wears clothes and appropriate footwear
when using GO BIKE.
• Be sure the rider keeps both hands on the handlebars for
proper control.
• Do not allow the rider to wear anything that obstructs
hearing and visibility or which impairs the functioning of
GO BIKE.
• The toy should be used with caution since skill is required
to avoid falls or collisions causing injury to the user or third
parties.
• Always wear safety equipment (helmet, elbow-pads, knee-
pads).
Assembling the product (See page 3-5)
Insert the handlebar stem into the fork stem, the minimum
insertion depth is that minimum insertion mark above the
word "MIN" on the stem are inserted.
Insert the saddle stem into the saddle tube of the main
frame. The minimum insertion depth is that minimum
insertion mark above the word "MIN" on the stem are
inserted.
Adjusting the GO BIKE:
Adjust the height of the saddle so that your child can easily
touch the ground with the complete soles of his or her feet
with slightly angled knees. The handlebar should be at a
height that allows the arms to be held roughly horizontally.
Test whether your child feels comfortable in this position and
check the adjustments regularly, and always respect the
levels of insertion.