Operations
My Cycles
Add or remove cycles to create a personal cycle list.
1. Tap UPPER or LOWER to select the upper or lower washer.
2. Tap Options.
3. Turn the Navigation dial to select My Cycles, and then tap OK.
-
You can only edit a cycle to create a personal cycle when the washer is not operating.
4. Turn the Navigation dial to select a desired cycle.
5. Tap OK to add or remove the selected cycle.
-
Addition and removal of the cycle is saved automatically.
6. Once you finish creating My Cycles, tap Options to return to the cycles screen.
NOTE
• The Normal, Self Clean (upper), and Self Clean+ (lower) cycles cannot be removed from the cycles list.
• You can also edit My Cycles in the SmartThings app.
Drum Light
You can turn the drum light on or off.
1. Tap Options.
2. Turn the Navigation dial to select Drum Light, and then tap OK.
3. Tap OK to select On or Off.
Delay End
You can set the washer to finish your wash automatically at a later time, choosing a delay of between 1 to 24
hours (in 1 hour increments). The hour displayed indicates the time the wash will finish.
1. Select a cycle and change the cycle settings as necessary.
2. Tap Options.
3. Turn the Navigation dial to select Delay End, and then tap OK.
4. Turn the Navigation dial to select the desired time, and then tap OK.
5. Tap and hold
.
-
Status shows in the display and the washer tumbles the drum to sense the weight of the load (if
load sensing is preset for the selected cycle). When load sensing is complete, the display shows the
remaining time until the end of the wash cycle.
-
To cancel Delay End, tap
52
English
Untitled-2 52
to restart the washer.
2021-05-17
2:04:35