Samsung FlexWash WV60A9900A Serie Manual De Usuario página 73

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Problem
The washer stops.
The washer fills with the wrong
temperature water.
The load is wet at the end of a
cycle.
Untitled-2 73
• Plug the power cord into a live electrical outlet.
• Check the fuse or reset the circuit breaker.
• Close the door, and then tap and hold
your safety, the washer will not tumble or spin unless the door is
closed.
• Before the washer starts to fill, it will make a series of clicking
noises to check the door lock and does a quick drain.
• There may be a pause or soak period in the cycle. Wait and the
washer may start.
• Make sure the mesh filters of the water supply hoses at the taps
are not clogged. Periodically clean the mesh filters.
• If the washer is not supplied with sufficient power, the washer
temporarily will not drain or spin. As soon as the washer regains
sufficient power, it will operate normally.
• Fully open both taps.
• Make sure the temperature selection is correct.
• Make sure the hoses are connected to the correct taps. Flush the
water lines.
• Make sure your water heater is set to supply hot water with a
minimum temperature of 120 °F (49 °C) at the tap. Also, check the
water heater capacity and recovery rate.
• Disconnect the hoses and clean the mesh filters. The mesh filters
may be clogged.
• While the washer fills, the water temperature may change as
the automatic temperature control feature checks the incoming
water temperature. This is normal.
• While the washer fills, you may notice just hot and/or just
cold water going through the dispenser when cold or warm
temperatures are selected. This is a normal function of the
automatic temperature control feature as the washer determines
the water temperature.
• Use the High or Extra High spin speed.
• Use high efficiency (HE) detergent to reduce oversudsing.
• The load is too small. Small loads (one or two items) may become
unbalanced and not spin completely.
• Make sure the drain hose is not kinked or clogged.
Action
to start the washer. For
English 73
2021-05-17
2:04:39

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido