Pioneer BDR-80FD Manual De Instrucciones página 52

08
Problem
Multi-channel sound is not
output.
Noise can be heard when
outputting DTS Digital Audio
signals from the DIGITAL
OUT terminal.
192 kHz or 96 kHz digital
audio signals cannot be
output from the DIGITAL
OUT terminal.
Secondary audio or
interactive audio is not
output.
After a disc is inserted,
Loading stays displayed and
playback does not start.
 is displayed in file names,
etc.
A message indicating low
memory appears while
playing a BD-ROM disc.
52
En
Check
Is the audio output of the
connected AV receiver or
amplifier, etc., properly set?
Is multi-channel sound
selected?
Is the connected AV receiver
or amplifier compatible with
DTS Digital Surround?
Is HDMI Audio Out properly
set?
Are Digital Output properly
set?
Are there too many files
recorded on the disc?
Remedy
Read the operating instructions for the connected AV receiver or
amplifier and check the audio output settings of the AV receiver or
amplifier.
Use the menu screen or AUDIO to switch the disc's sound to multi-
channel.
If an AV receiver or amplifier that is not compatible with DTS Digital
Surround is connected to the DIGITAL OUT terminal, set Digital
Output to PCM (page 38).
• Copyright-protected audio is converted to 48 kHz or less before
output.
• Set Max Sampling Frequency to 96KHz or 192KHz (page 38).
When listening to the sound from an HDMI OUT terminal, set HDMI
Audio Out to PCM (page 39).
When listening to the sound from an DIGITAL OUT terminal, set
Digital Output to Re-encode or PCM (page 38).
When a disc on which files are recorded is inserted, depending on the
number of files recorded on the disc, loading may take several dozen
minutes.
The characters that cannot be displayed on this player are displayed in
.
• Connect a USB device (page 19).
• Erase the data stored on the connected USB device from BUDA
Setup (page 42).