Install The Max Gearloft™ Shelf To The Gladiator ® Wall System - Gladiator MAX GEARLOFT GAGL30WSJG Instrucciones De Ensamblaje

INSTALL MAX GEARLOFT™ SHELF TO THE GLADIATOR
1.
Installing the GearTrack
6" (15.24 cm)
Be sure the Gladiator GearWall
®
are installed with mounting screws in every slot and at every stud
location with a maximum of 24" (60.96 cm) horizontally between
screws.
If installing the shelf on GearTrack
channels installed 6" (15.24 cm) apart.
3.
Installing Max GearLoft™ Shelf
A. Brace attached to the Shelf
B. Shelf attached to GearTrack
Engage the bracket that is welded to the back of the shelf into the
wall slot by lifting up, pushing toward the wall and lowering the
bracket rim into the slot as shown.
channel
®
panels or GearTrack channels
® ®
channel, you must use two
®
A
B
®
2.
Sliding the brackets into the
GearTrack
Determine the shelf mounting location on Gladiator
panels or GearTrack channel.
®
Insert the brackets into the GearTrack
rim extension fits behind the upper channel groove.
Slide the brackets in the GearTrack
spaced 43" (109.22 cm) apart as shown in above figure.
NOTE: Install bracket into the upper channel for installations
with the braces above the shelf, or into the lower channel for
installations with the braces below the shelf.
4.
Fasten the braces to the brackets
A. Wing nut
Make sure that the screws on the brackets go through the holes
in the braces. Fasten the braces to the brackets using the wing
nuts (F3).
NOTE: You may need to adjust the brackets to the right or left if
the screws do not align with the holes.
Inspect the shelf from the side to ensure the bracket rims are fully
engaged in the slots as shown.
Fully tighten the wing nuts (F3).
WALL SYSTEM
®
channel
®
GearWall
®
channel so that bracket
®
channel so that they are
®
A
®
5