Install Leveling Legs - Gladiator GAGB28KDYG Instrucciones De Ensamblaje

2.
Attach Lower Back Panel
F3c Phillips-head screw (7)
P3
P6
P4
Using seven Phillips-head screws (F3c), attach the lower back
panel (P6) to the bottom (P4) and sides (P1 and P3) as shown.
Tighten screws completely. Using the hex key (provided),
completely tighten all the cabinet bolts and nuts.
F3c
P2
P1
3.

Install Leveling Legs

P1
P6
P4
A. Leveling legs
NOTE: The Gladiator Modular GearBox is designed to be
®
either stationary or to roll on casters. To order the Gladiator
Steel Modular GearBox Caster Kit, see "Accessories." Place the
cabinet on its side. Screw a leveling leg (P7) into each of the four
rivet nuts located at the corners of the cabinet as shown. Stand
the cabinet upright. If you have not already, fasten the two bolts
at each front corner, of the cabinet frame. Completely tighten all
the cabinet bolts and nuts.
P7
A
®
5