Prior To Operation - Metabo HPT M 1808DA Instrucciones De Seguridad Y Manual De Instrucciones

Fresadora de cantos a batería
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

(4) Fit the removed base ass'y to the rack provided on the
body's outer housing after adjusting the pinion of the
base ass'y thereto. Then tilt the lock lever towards the
fi x side, and fi x the base ass'y securely.
When removing the bits, do so by following the steps
for installing bits in reverse order.
2. Install without using the lock pin
(1) Remove the base ass'y from the body.
(2) Deeply inset the bit into the collet cone hole. (The
distance is 15 mm or more from side of collet nut.)
(3) Use a 13 mm Wrench to secure the shaft, and
securely tighten the collet nut with the included
wrench. (Fig. 10)
23 mm Wrench
Tighten
Loosen
Bit
(4) Fit the removed base assembly to the rack provided
on the body's outer housing after adjusting the pinion
of the base assembly thereto. Then tilt the lock lever
towards the fi x side, and fi x the base ass'y securely.
When removing the bits, do so by following the steps
for installing bits in reverse order.
NOTE
○ Ensure that the collet nut is fi rmly tightened after
inserting a bit. The collet cone may become deformed
if the collet cone is tightened without a bit set in place.
○ Ensure that the lock pin is not inserted into the shaft
after tightening the collet cone. Failure to do so will
result in damage to the lock pin and shaft.
○ Use only trimmer bits of which the maximum speed,
as indicated on the bit, does exceed the maximum
speed of the trimmer.
3. Exchanging the collet cone
(1) Securing the shaft, remove the collet nut, and
exchange the collet cone.
(2) Attach the nut, insert the bit, and tighten the nut.
(Fig. 11)
13 mm Wrench
Collet nut
Fig. 10
Collet cone
(6.35 mm)
Collet nut

PRIOR TO OPERATION

WARNING
To avoid a serious accident, press the power
button located on the switch panel to turn the
power OFF, and pull out the battery.
1. Installation direction of base ass'y
The switch position can be changed according to
preference by reversing the installation direction of
the base ass'y.
(1) Tilt the lock lever towards the remove side, and
remove the base ass'y from the body. (Fig. 12-a)
(2) Rotate 180 degrees, and place back in the base ass'y,
then tilt the lock lever towards the fi x side. (Fig. 12-b)
Rack portion
Pinion
English
Collet cone
(9.5 mm)
Fig. 11
Pull out
Remove
Lock lever
a
b
Fig. 12
13

Publicidad

Tabla de contenido
loading

Tabla de contenido