English
● To avoid injury from an accidental start, turn the switch OFF and remove the plug from the power source
or remove the battery from the main body before making any adjustments.
● All electrical or mechanical repairs should be done only by qualifi ed service technicians. Contact
metabo HPT Authorized Service Center.
1. Power tool
Problem
Tool doesn't run
Tool suddenly stopped
Doesn't cut well
Remaining battery
indicator lamp is blinking
Remaining battery
indicator on the machine
doesn't match to Multi volt
battery
Battery cannot be
installed
2. Charger
Symptom
The charge indicator lamp
rapidly fl ickers purple, and
battery charging doesn't
begin.
The charge indicator lamp
blinks red, and battery
charging doesn't begin.
24
TROUBLESHOOTING GUIDE
WARNING
Possible Cause
No remaining battery power
Battery isn't fully installed.
The power is OFF.
Tool was overburdened
Battery or tool overheated
No remaining battery power
The bit is worn or missing teeth.
The collet chuck is loose.
Indicates that the remaining battery charge
is very low.
—
Attempting to install a battery other than
that specifi ed for the tool.
Possible cause
The battery is not inserted all the way.
There is foreign matter in the battery
terminal or where the battery is attached.
The battery is not inserted all the way.
The battery is overheated.
Remedy
Charge the battery.
Push the battery in until you hear a click.
Press the power button to switch the power
ON.
Get rid of the problem causing the
overburden.
During operation, lighten the applied
pressure.
Allow the tool and battery to thoroughly
cool.
Charge the battery.
Replace with a new bit.
Firmly tighten the collet chuck.
Recharge as soon as possible.
Refer to the indicator lamp on the battery.
Please install batteries that are multi volt or
BSL18xx series.
Remedy
Insert the battery fi rmly.
Remove the foreign matter.
Insert the battery fi rmly.
If left alone, the battery will automatically
begin charging if its temperature
decreases, but this may reduce battery
life. It is recommended that the battery be
cooled in a well-ventilated location away
from direct sunlight before charging it.