Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
5. About Remaining Battery Indicator
When the power is ON, the remaining battery
indicator lamp lights and the battery remaining power
can be checked. (Fig. 32) The Table 6 shows the state
of remaining battery indicator lamp and the battery
remaining power.
State of lamp
NOTE
○ If only one lamp of the remaining battery indicator
lamp is blinking, the remaining battery charge is very
low. The battery should be recharged as soon as
possible.
○ Do not give a strong shock to the display panel or
break it. It may lead to a trouble.
As the remaining battery indicator shows somewhat
diff erently depending on ambient temperature and
battery characteristics, read it as a reference.
Table 6
Battery Remaining Power
The battery remaining power is
enough.
The battery remaining power
is a half.
The battery remaining power is
nearly empty.
Re-charge the battery soonest
possible.
No remaining battery charge
Power button
Fig. 32
OPERATIONAL CAUTIONS
Resting the unit after continuous work
(1) The power tool is equipped with a temperature
protection circuit to protect the motor.
Continuous work may cause the temperature of the
unit to rise, activating the temperature protection
circuit and automatically stopping operation.
If this happens, allow the power tool to cool before
resuming use.
(2) After use for continuous work, rest the unit for
15 minutes or so when replacing the battery. The
temperature of the motor, switch, etc., will rise if
the work is started again immediately after battery
replacement, eventually resulting in burnout.
English
21
Publicidad
Tabla de contenido
