Load A Disc - Lenco SCD-50 BT Manual De Instrucciones

HANDLE AND MAINTAIN A COMPACT DISC.
Follow the instructions below to handle and maintain your disc in
order that long time and trouble free performance can possibly be
obtained:
 Ensure not to caress the rain bow side of the disc; handle the
disc by the edge.
 Long time exposure to sunshine, high temperatures and
humidity will damage the disc. Keep the storage area clean.
 Avoid sticking labels on both sides of a disc. Writing with
pointed articles on the disc should be strictly avoided.
 Clean the disc wiping the centre and then working out to the
edge with a dry & soft cloth or a disc brush. Avoid any
cleansing lotion or chemical eradicator.
 Store them in their cases when they are not to be used.

LOAD A DISC

1. Power on the unit.
2. Press the FUNCTION button repeatedly to switch to the CD mode.
3. Open the CD door.
4. Insert a disc with the label side facing upward (if the disc is upside down, the display will
indicate no disc on the screen).
5. Close the CD door by hand.
NOTE: Never touch the laser lens inside the CD compartment. If it ever gets dirty, clean it
with a CD cleaner disc.
REMOVE A DISC
1. Make sure the disc is not playing. If it is, press the STOP/M+ button.
2. Open the CD door.
3. Gently remove the disc.
4. Close the CD door by hand.
5. Replace the disc in its protective storage box.
PLAY A CD/MP3 DISC
1. Power on the unit, press the FUNCTION button repeatedly to switch to the CD mode.
2. Load a CD/MP3 disc into the CD compartment. Close the CD door, the disc will begin to
spin.
3. Adjust the volume level to the desired volume level by using the VOLUME UP/DN control
knob.
4. When the disc is successfully read, the total number of the disc shows on the display, the
playback starts automatically.
5. Press the PLAY/PAUSE/PAIR button once to halt music playback, the elapsed time of the
current track flashes to indicate the player in Pause mode; press the STOP/M+ button to
cease music playback, the LCD shows the total number of the tracks.
6. Press the MODE/PROG/MEM button repeatedly to switch among the play modes (repeat
1, repeat All, introduction and random play modes).
7. Press the POWER button to turn off the unit.
EN-3
HANDLE DISC ONLY AS SHOWN
CLEAN FROM CENTER TO EDGE
DO NOT STORE NEAR HEAT