Char-Broil 14101480 Guía Del Producto página 4

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

USE AND CARE
LP Cylinder Exchange
•Many retailers that sell grills offer you the option of
replacing your empty LP cylinder through an exchange
service. Use only those reputable exchange companies
that inspect, precision fill, test and certify their cylinders.
Exchange your cylinder only for an OPD safety
feature-equipped cylinder as described in the "LP
Cylinder" section of this manual.
•Always keep new and exchanged LP cylinders in upright
position during use, transit or storage.
•Leak test new and exchanged LP cylinders BEFORE
connecting to grill.
•Place safety cap on cylinder valve outlet whenever the
cylinder is not in use. Only install the type of safety cap
on the cylinder valve outlet that is provided with the
cylinder valve. Other types of caps or plugs may result in
leakage of propane.
LP Cylinder Leak Test
For your safety
•Leak test must be repeated each time LP cylinder is
exchanged or refilled.
•Do not smoke during leak test.
•Do not use an open flame to check for gas leaks.
•Grill must be leak tested outdoors in a well-ventilated
area, away from ignition sources such as gas fired or
electrical appliances. During leak test, keep grill away
from open flames or sparks.
•Use a clean paintbrush and a 50/50 mild soap and water
solution. Brush soapy solution onto areas indicated by
arrows in figure below.
• Do not use household cleaning agents. Damage to
gas train components can result.
WARNING
If "growing" bubbles appear do not use or move the LP
cylinder. Contact an LP gas supplier or your fire
department!
Connecting Regulator to the LP Cylinder
1.LP cylinder must be properly secured onto grill. (Refer
to assembly section.)
2.Turn all control knobs to the OFF position.
3.Turn LP cylinder OFF by turning hand-wheel clockwise
to a full stop.
4.Remove the safety cap from LP cylinder valve. Always
use cap and strap supplied with valve.
Safety Relief Valve
Strap and Cap
Do not use a POL transport
plug (plastic part with
external threads)! It will
defeat the safety feature of
the valve.
5.Hold regulator and insert nipple into
LP cylinder valve. Hand-tighten the
coupling nut, holding regulator in a
straight line with LP cylinder valve
so as not to cross-thread the
connection.
Nipple has to be centered
into the LP cylinder valve.
6.Turn the coupling nut clockwise and tighten to a full stop.
The regulator will seal on the back-check feature in the
LP cylinder valve, resulting in some resistance. An
additional one-half to three-quarters turn is required
to complete the connection. Tighten by hand only –
do not use tools.
NOTE:
If you cannot complete the connection, disconnect
regulator and repeat steps 5 and 6. If you are still unable
to complete the connection, do not use this regulator!
• Do not insert any tool or foreign object into the valve
outlet or safety relief valve. You may damage the
valve and cause a leak. Leaking propane may result
in explosion, fire, severe personal injury, or death.
• Do not use grill until leak-tested.
• If a leak is detected at any time, STOP!
• If you cannot stop a gas leak by closing the LP cylinder
valve leave area and call your fire department!
OPD Hand Wheel
Leak Testing Valves, Hose and Regulator
Type 1 outlet with
1.Turn all grill control knobs to OFF.
thread on outside
2.Be sure regulator is tightly connected to LP cylinder.
3.Completely open LP cylinder valve by turning hand
wheel counterclockwise. If you hear a rushing sound,
turn gas off immediately. There is a major leak at the
connection. Correct before proceeding.
4.Brush soapy solution onto areas circled.
Coupling nut
Hold coupling nut
and regulator as
shown for proper
connection to LP
cylinder valve.
DANGER
WARNING
4
5.If "growing" bubbles appear, there is a leak. Close
LP cylinder valve immediately and retighten
connections. If leaks cannot be stopped do not try
to repair. Call for replacement parts.
6.Always close LP cylinder valve after performing leak
test by turning hand wheel clockwise.
WARNING
• Outdoor gas appliance is not intended to be installed
in or on a boat.
• Outdoor gas appliance is not intended to be installed
in or on an RV.
• Never attempt to attach this grill to the self-contained
LP gas system of a camper trailer or motor home.

Publicidad

Tabla de contenido
loading

Tabla de contenido