Cleaning/Maintaining The Fire Pit; Safety Notes - Enders NOVA LED L Serie Manual De Montaje Y Uso

NOVA LED L | NOVA LED M
CLEANING/MAINTAINING

SAFETY NOTES

!
Despite careful processing of all individual parts,
individual components may have sharp edges.
Always wear protective gloves in order to avoid
injury.
Hot surface: Before cleaning, wait until it has had
sufficient time to cool.
RISK OF FIRE AND EXPLOSION
Do not use flammable cleaning agents.
HANDLING OF THE GAS SYSTEM
Repairs and maintenance to components carrying
gas may only to be carried out by authorised
specialists.
Do not use abrasive or chlorinated cleaning agents.
Wipe dirty surfaces with a damp cloth or rinse
with hot water. If necessary, use a mild cleaning
agent. Rinse with water and dry all surfaces with a
microfibre cloth.
When using a mild cleaning agents, also observe
the notices/product information of the product
manufacturer to prevent damaging the surface.
Allow the device to dry completely before using it
again.
Item no.: 5600 | 5601 | 5602 | 5603 | 5604 | 5605 | 5606 | 5607
Do not modify the patio flame heater or pressure
regulator in any way. The hose must be serviced
after 5 years (see manufacturing date on the hose).
Replace the pressure regulator and the hose after
10 years at the latest even if there are no obvious
signs of damage. Make sure that the pressure
regulator is approved for your country and the gas
used and is set the to the correct output pressure
(see Technical data). A new hose may not be longer
than 1.5 metres.
Manipulation or changes to components sealed by
the manufacturer is strictly forbidden.
If the gas comes into contact with oil it creates an
explosive mixture. Never try to loosen tight valves
and control knobs with oil or penetrating oil.
33