Hama 6in1 Instrucciones De Uso página 12

7.2 Activating the learning mode
1. Press and hold the [MUTE] and [VOL+] buttons simultaneously for approx.
3 sec. until the status LED lights up continuously.
2. Use the device button to select the device (e.g. [TV]) for which a new
function is to be taught. A successful selection is con rmed by the status
LED ashing once and then lighting up continuously.
3. Enter the code [9] [8] [0], the status LED ashes 2 times and then lights up
permanently.
4. The universal remote control is now in learning mode.
Note
• If the status LED ashes 8 times and the learning mode ends automatically,
you have already taught too many buttons and the available memory is full.
The remote control can store a maximum of 125 taught-in buttons.
• If no device selection is made, the last device selection made is automati-
cally used.
7.3 Transferring the button function
1. Press the button on the original remote control whose function you want
to transfer. To con rm that the command has been received, the status LED
of the universal remote control ashes.
2. Now press the button on the universal remote control to which the func-
tion is to be transferred.
3. The function LED of the universal remote control ashes 3 times for con-
rmation and then lights up permanently again. The new function is now
saved.
4. To transfer the functions of additional buttons, repeat these steps.
5. Press the [SETUP] button to save all taught-in functions and exit the
learning mode.
Note
When changing the batteries of the universal remote control, the functions of
the taught-in buttons are retained.
7.4 Deleting taught functions
7.4.1 Deleting a taught function
1. Press and hold the [MUTE] and [VOL+] buttons simultaneously for approx.
3 sec. until the status LED lights up continuously.
2. Select the device you want to clear a learned command using the device
key ( e.g. [TV] ). A successful selection is indicated by the LED with one
ash followed by permanent light.
3. Enter the code [9] [8] [1], the status LED ashes 2 times and then lights up
permanently again.
4. Press the button whose function you wish to
want to delete. The status LED ashes 4 times and the desired function is
deleted.
10