MO8113
EN
Power bank with 26 cm USB cable with micro USB adapter.
Operating instructions
Use the Micro input port to charge power bank and use the USB output port to charge other equipment
Charging instructions:
•
Charging electronics digital equipment:
Please choose the suitable connector according to your electronic digital products.
Whilst connected with the device the power bank will begin to charge the device. Please unplug the charging cable
after charging is complete.
•
Charging power bank:
Connect the power bank with a DC USB port. Plug the micro USB cable in to the power bank to recharge.
The charging indicators will be red when charging the power bank, when the charging indicator turns off this indicates
the power bank is fully charged. The indicator light will be green when charging other electronic devices.
Specification:
Input:
DC5V/1A
Output:
DC5V/1A
Capacity:
2400mAh
Power Efficiency:
84%
Charging time:
4-5 hours approx.
Cycle life:
500 times approx. OR 3 years approx.
Protection voltage: 5.5
•
When connecting the power bank to the device, please use the charging cables and connectors provided from the
authorized maker. The use of charging cables or connectors from unauthorized makers may cause severe or fatal
injuries and property losses as well as damage to the product and the device connected.
•
Power Bank is compatible with Apple® Product USB Cable/ adapter (Not Included).
•
If the product does not start charging when it is connected to a device, please disconnect all cable and try again and
check if the power bank is charged.
Note:
-
Battery may explode if disposed of in fire
-
Dry location use only
-
Shock hazard – Do not open
-
Do not overheat batteries by exposure under high temperature and direct sunlight
-
A battery should NOT be exposed to water
-
Exhausted batteries should be immediately removed from equipment and disposed of only through approved outlets
-
Please remove the power source after full charging
-
Please keep out of reach of children. Do not use/ leave product unattended whilst in use