Kohler K-73081 Guía De Instalación Y Cuidado página 5

Grooved Washer
Small O-Ring
Large O-Ring
Supply Tube
Plate
Screw
Washer
Nut
2. Install the Supply Tube
Insert the large O-ring into the large groove in the washer, and
the small O-ring in the small groove on the opposite side of the
washer.
With the large O-ring in the washer and facing down, position
the washer over the mounting hole. Carefully insert the supply
tube assembly through the washer and mounting hole.
Orient the tabs on the plate up. Slide the plate onto the supply
tube assembly from underneath until flush with the underside of
the deck/rim. Secure with the screws. Slide the flat washer onto
the supply tube assembly, then wrench tighten the nut.
Install the pipe plug (not shown) into the top of the supply tube.
Kohler Co. 5 1276523-2-A