OPERATING INSTRUCTIONS
DOOR REVERSAL INSTRUCTIONS
If the appliance is placed on its back or side for any
length of time during this process, it must be allowed to
remain upright for 6 hours before plugging it in to avoid
damage to the internal components.
1. Remove the screw from the upper hinge and remove
the upper hinge and the freezer door. Remove the
screws from the left side of the worktop and set them
aside. These screws will be used to reattach the upper
hinge. See fi gure A.
2. Remove the screws from the center hinge. Remove
the center hinge, the center hinge spacer and the
refrigerator door. See fi gure B.
3. Move the bushing from the top right side to the top
left side of the refrigerator door. See fi gure C.
4. Remove the right door stop from the bottom of the
refrigerator door. See fi gure D.
5. Remove the lower hinge from the right side of the
cabinet, then install the lower hinge on the left side of
the cabinet. See fi gure E.
6. Get the left door stop from the accessory bag, install
it on the bottom left side of the refrigerator door. See
fi gure F.
7. Remove the center hinge screw hole plugs and install
them in the screw holes on the right side of the
cabinet. See fi gure G.
8. Install the refrigerator door. Install the center hinge.
Ensure that the center hinge spacer is installed with
the center hinge as the spacer is necessary to allow
the doors to have full range of motion. Get the left
upper door stop from the accessory bag, install it on
the bottom left side of the freezer door. See fi gure H.
9. Install the freezer door. Install the upper hinge on the
top left side of the cabinet. See fi gure I.
1. Upper Hinge
2. Screws
3. Center Hinge Spacer
4. Center Hinge
5. Bushing
6. Right Door Stop
7. Lower Hinge
8. Left Door Stopper
9. Screw Hole Cover
Note: When reinstalling
the refrigerator and freezer
doors, ensure that the
rubber gaskets are making
a good seal with the
cabinet before tightening
the screws.
A
B
C
D
E
F
G
H
I
5
1
2
3
4
2
5
5
6
2
7
2
8
2
9
3
4
2
5
1
2