Lists Of Device Functions And Components; Preparatory Work - bredent ecovac 14000930 Manual De Funcionamiento Y Mantenimiento

5.2 Lists of device functions and components

(1) Speed regulator
(2) Time display
(3) Time setting
(4) Mixing function START/STOP
(5) ON/OFF
(6) Mixing/suction connections
(7) Vacuum I = START / O = STOP
(8) Vacuum display
(9) Vacuum changeover switch
(10) Lower „hole" for bottom bracket
(11) Schalldämpfer
(12) Typenschild
Check whether the mains data are identical with the information specified on the type plate (12). Before con-
necting the device to the mains supply, read the operation and maintenance instructions carefully, in particular
the safety and hazard information, information on assembly and list of device functions and components pro-
vided in the instructions! The silencer (11) is not assembled to the device for reasons of transport safety. It is
assembled to the unit before initial operation.

5.3 Preparatory work

Select the mixing cup with the appropriate filling quantity (see 5.5) for the material to be mixed. The filling
quantity must not be exceeded, as otherwise there is the risk that the material will be sucked in too high by the
vacuum. This could result in contamination of the prefilter. Mix the material that requires mixing in accordance
with the manufacturer's information in the instructions for use. Ensure that the edge of the cup is free of
contaminants, as the lid of the mixing spiral will otherwise not close fully and a vacuum will therefore not be
generated. Switch on the main switch (5) on the bottom right of the device. The time for the mixing process will
be stated by turning the adjustment knob (3) and will be displayed on the digital time display (2). The desired
speed is set on the speed regulator (1).
16
(increments: 290 – 600 rpm)
(min./sec; 0:00 – 9:50)
(-/to reduce+/to increase)
(Programme sequence)
(mains plug, bottom right of the device)
(stirrer-cup slot)
(vacuum pump)
(I=partial vacuum / II=full vacuum)
(change of position I or II
bredent GmbH & Co.KG · Weissenhorner Str. 2 · 89250 Senden · Germany · Tel. +49 7309 872-22 · Fax +49 7309 872-24
www.bredent.com · e-mail info@bredent.com