Wiring - Craftmade WSP70 Manual Del Usuario

6. Wiring.

WARNING: Turn off circuit breakers to current fixture from
breaker panel and be sure switch is turned to the OFF
position
CAUTION: Be sure outlet box is properly grounded and that
a ground wire (GREEN or Bare) is present.
Make sure all electrical connections comply with Local Codes
or Ordinances and the National Electrical Code. If you are
unfamiliar with electrical wiring or if the house/building
wires are different colors than those referred to in the
diagram to the right, please use a qualified electrician.
Pull extra wire slack from the upper end of the downrod.
When downrod is secured in place on the hanging
bracket, wire the receiver as follows:
Connect 3-wire plug from fan to 3-wire plug from remote
control receiver. Connect 2-wire plug from fan to 2-wire
plug from remote control receiver. Make sure plugs snap
together completely.
Connect BLACK wire from remote control receiver to
BLACK wire from ceiling with wire connector provided.
Connect WHITE wire from remote control receiver to
WHITE wire from ceiling with wire connector provided.
Connect all GREEN wires together (from fan and remote
control receiver) to BARE/GREEN wire from ceiling with
wire connector provided.
* Wrap each wire connector separately with electrical tape
as an extra safety measure.
Gently insert receiver (flat side up) into hanging bracket
and carefully push taped wire connectors into outlet box.
Let antenna rest outside of hanging bracket.
PLEASE NOTE: Wall and/or remote conrol must be used
for fan to operate. If you do not wish to use the wall
control, please proceed to Section 7 to continue with fan
installation.
IN ORDER TO WIRE WALL CONTROL, remove existing
wall switch. Wire the WALL CONTROL with wire
connectors provided as shown in diagram at right.
* Wrap each wire connector separately with electrical
tape as an extra safety measure. Gently push wires and
taped wire connectors into outlet box.
Install battery (included) in wall control.
IMPORTANT: Wall control will not function unless
battery is installed.
WARNING: CONNECT WIRES IN THE FOLLOWING
ORDER ONLY!
Connect GREEN/YELLOW ground wire to ground from
house or directly to one of the screws from the outlet
box.
Connect one BLACK wire from wall control to BLACK
(hot) lead wire from house. Connect second BLACK wire
from wall control to BLACK load wire to fan.
Attach wall control to outlet box and secure with screws
from original wall switch. Attach front plate to wall
control using 2 screws provided in the wall control.
white supply wire
black supply wire
2-wire plug
yellow
brown
pink
from fan
3-wire plug
from
receiver
white
blue
(wiring for receiver)
outlet box
green/
bare
ground
black
(TO POWER supply)
black
(AC IN from
breaker box)
(wiring for wall control)
page 6
ground (green
or bare)
black
white
from ceiling
green
from fan
from receiver
antenna
AC IN N
white
AC IN L
black
green
receiver
wall
control
3 4
2
5
1 6
green/yellow
black (OUT to fan)
black
ground (green
or bare)
*
plate