Wiring - Craftmade ELLINGTON E-BEL52BNK3CRW Guia De Instalacion

6. Wiring.

CAUTION: Be sure outlet box is properly grounded
and that a ground wire (GREEN or Bare) is present.
Make sure all electrical connections comply with
Local Codes or Ordinances and the National
Electrical Code. If you are unfamiliar with electrical
wiring or if the house/building wires are different
colors than those referred to in the diagram to the
right, please use a qualified electrician.
When downrod is secured in place on the
hanging bracket, wire the RECEIVER with wire
connectors provided as shown in diagram at
right.
Tip: While you are wiring, keep in mind that wires
must not obstruct receiver from sliding into
hanging bracket.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
Gently insert receiver (flat side up) into hanging
bracket and carefully push taped wire
connectors into outlet box. Allow antenna from
remote control receiver to hang outside of
hanging bracket.
IN ORDER TO WIRE WALL CONTROL, remove
existing wall switch. Wire the WALL CONTROL
with wire connectors provided as shown in
diagram at right.
* Wrap each wire connector separately with
electrical tape as an extra safety measure. Gently
push wires and taped wire connectors into
outlet box.
Use a ballpoint pen or a small screwdriver to set
the code switches 1 through 4 on the wall
control. Factory setting is pre-set and not
recommended for use. Write down number
sequence for use in Section 10.
Note: Since this fan comes with candelabra base
bulbs, the dimmer switch (labeled D and X) has
been pre-set to the "ON" position (D). If you do
not wish to have dimming capability, please
move the switch to the "OFF" position (X).
Attach wall control to outlet box and secure with
screws from original wall switch. Attach front
plate to wall control using 2 screws provided
with the wall control.
Modifications not approved by the party responsible for compliance
could void the user's authority to operate the equipment.
*NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
white supply wire
black supply wire
blue
black
white
from fan
from receiver
white
black
blue
(wiring for receiver)
outlet box
(AC IN from
breaker box)
(wiring for wall control)
page 6
ground (green
or bare)
from ceiling
from receiver
black
AC IN L
white
AC IN N
receiver
antenna
wall
control
green/ green/ green/
bare bare bare
ground ground ground
green
black (OUT to fan)
black
black
(TO POWER supply)
black
ground (green
or bare)
black
*
plate
code
switches
dimmer
switch